Re: ZMQ Message Debug

Hi Jay,

first of all: that's GNU Radio 3.7. Time to upgrade, really! No excuse. You're building a
new something, and you're starting with something that has been legacy for years now.
ZMQ and networking blocks have seen many improvements, so, you're really ill-advised to
stick with GNU Radio 3.7

Then: puh, this is incredibly complex. When debugging something, reduce to as little
blocks as necessary to reproduce the problem. You've not done that, and I really can't
tell where the problem here lies!

Best regards,
Marcus

On 07.03.21 21:06, Jay Patel wrote:
> Hi all,
>
> I am sending messages from an external application via (ZMQ PUSH) and received those
> messages in the GNURadio via ZMQ Pull message source. 
>
> From the ZMQ PULL side, I had correctly debugged the message coming from external
> applications.
>
> I want to basically transmit those messages. But in the receiver side after the Tagged
> stream to PDU ->  message debug block don't print anything. I put a QT Freq sink to check
> if the data is coming properly or not.  
>
> Did I miss something? How can I properly debug the messages. I had attached my flow graph.
>
> Any suggestions are welcome.
>
> */With Regards,/*
> /Jay Patel/
>