I have tested this again and again. I cannot get audio out of the did block. I will post the .py in the morning. I just need a direction
Sent from my BlackBerry — the most secure mobile device — via the Bell Network
| From: mspears@icmt.ca Sent: September 22, 2020 7:21 AM To: mmueller@gnuradio.org; discuss-gnuradio@gnu.org Subject: Re: gr-dsd help needed |
I will add a sink between the did and rational resampler and test again. Other then that does the flow graph look correct.
I am using a B210 UHD
Sent from my BlackBerry — the most secure mobile device — via the Bell Network
| From: mmueller@gnuradio.org Sent: September 22, 2020 7:14 AM To: discuss-gnuradio@gnu.org Subject: Re: gr-dsd help needed |
Is it possible the output rate of your DSD block isn't actually as high
as you think it is?
On 21.09.20 20:03, Martin Spears wrote:
> I am attempting to use gr-dsd for dmr audio. Can someone please tell me what I am doing wrong. This sounds like a chipmunk with a speech impediment
>
> Martin Spears
>
>
as you think it is?
On 21.09.20 20:03, Martin Spears wrote:
> I am attempting to use gr-dsd for dmr audio. Can someone please tell me what I am doing wrong. This sounds like a chipmunk with a speech impediment
>
> Martin Spears
>
>
No comments:
Post a Comment