Re: [Discuss-gnuradio] Transmission issue in USRP N210

Hi Marcus,

> Can you ping the N210?

Yes. "ping 192.168.10.2" works fine.

> If you use: uhd_usrp_probe --args addr=192.168.10.2, What happens?

"uhd_usrp_probe" also works fine. Couldn't check with --args. I am away from the board now for few hours. Until then...

> Is your ethernet interface configured for 192.168.10.1 ?

Yes. Configured statically in "/etc/network/interfaces" file.

Thanks,

Zamrath Nizam

On Tue, Apr 7, 2015 at 6:13 PM, Marcus D. Leech <mleech@ripnet.com> wrote:

On 04/07/2015 08:14 AM, Zamrath Nizam wrote:

Hi all,

I have recently installed openbts-2.8 on a banana-pi (Processor: armv7) board to work with USRP N210. Had all the pre-requisite installations and procedures been done, I noticed that, the transmitter is not working.

Though this issue seems to be related with openbts but since they are not responding, I would like to have some suggestions from you to resolve this issue.

In a previous thread 'Marcus' has stated that LED A is not working because openbts is not talking to USRP. i.e. USRP is not configured to receive samples.

Is he pointing to a receiving issue (probably I was looking for a transmission issue) or am I the one who is confused?

Can anyone please shed some light on this.

Thank you.

Best,

Zamrath Nizam

_______________________________________________  Discuss-gnuradio mailing list  Discuss-gnuradio@gnu.org  https://lists.gnu.org/mailman/listinfo/discuss-gnuradio  

Can you ping the N210?

If you use:

uhd_usrp_probe --args addr=192.168.10.2

What happens?

Is your ethernet interface configured for 192.168.10.1 ?

_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio