Re: [Discuss-gnuradio] mimo beam forming on USRP

Can you give us some details (frequency, number of antennas) that you
want to have?

A lot of people have done MIMO with USRPs, up to 100x100 antennas, so
there is some precedent. For beam forming, you'll need very good phase
alignment, depending on what you're planning to set up. This is always
difficult, because all sorts of things affect phase. You should, in any
case, have a way to test phase alignment.

Cheers,
Martin

On 03.03.2015 08:18, mleech@ripnet.com wrote:
> If you use the phase-resynch feature of the SBX card, and you have
> common refclock and 1PPS across all your USRPs in the array,
> then you should be OK.
>
> In *general*, synthesized downconverters use fractional-N synthesizers
> where their starting phase after a re-tune is random with respect to any
> other synthesizer using the same reference clock. That's just the way
> fractional- N synthesis works. It happens that SBX uses an ADF4351
> synthesizer, which has a (rare!) hardware feature to allow phase-resynch
> after tuning. In order to make this work, all SBXes in your "array"
> must be tuned at exactly the same time, so the timed_commands feature
> must be used to do the tuning.
>
> See:
>
> http://files.ettus.com/manual/page_sync.html
>
> On 2015-03-03 11:05, Pengyu Zhang wrote:
>
>> Hi Guys,
>> I am planning to build a mimo system which supports beam forming. Is
>> USRP a good platform for my target? I do not want to use WARP because
>> I need to operate at frequencies lower than 2.4GHz.
>> A potential problem of USRP is phase alignment. As the following doc
>> suggests, phase alignment can be done by MANUALLY tuning the phase.
>> This process can be labor intensive when the number of antennas
>> increases. I am also worried about the problem that the manual phase
>> calibration might need to be done each time you use the mimo system.
>> Is there any approach that can make this process much easier?
>> http://www.ettus.com/content/files/kb/mimo_and_sync_with_usrp_updated.pdf
>> Would be great if you can give me some suggestions about what devices
>> should I use for building a mimo system for beam forming. Thanks.
>> Pengyu
>>
>> _______________________________________________
>> Discuss-gnuradio mailing list
>> Discuss-gnuradio@gnu.org <mailto:Discuss-gnuradio@gnu.org>
>> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>
>
> _______________________________________________
> Discuss-gnuradio mailing list
> Discuss-gnuradio@gnu.org
> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>


_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio