[Discuss-gnuradio] Decoding FSK modulated signal

Hey,

I've some home automation equipment here using the sub-ghz band that I
managed to capture with a RTL dongle. From the data sheet and the
register settings of the TI CC1100 transceiver chip that is used inside
the device I figured out the RF parameters used, i.e. 102kHz channel
bandwidth, 2-FSK modulation, 19.2k baudrate, syncbyte etc.

Attached is a screenshot of a GRC waveform I used to capture the
preamble of a single packet. Channel 2 is simply the output of a
quadrature demod block connected to a scope GUI block. I'd like to
decode that into a sequence of bits to run preamble detection etc.

I've seen a few OOT modules that do similar stuff but was wondering if
there is a GR'ish way to this, maybe a set of generic blocks that could
be used for that?

Thanks
Andre

[1] http://i61.tinypic.com/35mjm08.png


_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio