Re: Trying to receive data from wifi_rx using gr-ieee802-11

Hi Karl - isn't the frequency of conventional wifi on the order of 2400 MHz (or 2.400000 GHz)  where the width of a single channel is on the order of 22 MHz - at the minimum?

And there are multiply flavors of wifi too with higher frequencies and bandwidths.

There might a problem with  your qt chooser for freq?

-- Cinaed

On 10/3/22 15:58, Karl Dawson wrote:

Hi All,

I'm using GNU Radio installed as part of an Instant GNURadio 3.8.2.0 VM. I've installed gr-ieee802-11 maint version 3.9, and am using it with a bladeRF. I've also tried to get this going with a hackRF.

It appears to all be running, and the wifi_rx example script appears to run as shown below:

Irrespective of the frequency I select however, I don't appear to be receiving any data in the Wireshark file sink, other than the occasional malformed packet:

I've tried setting the frequency to the frequency/channel that Windows says my laptop is operating on, but no luck. 

Is there something I'm fundamentally doing wrong? Any help would be greatly appreciated!

All the best,

Karl