Re: Promblems with gr-air-modes in gnuradio 3.10

Hi Cinaed,

thank you for your answer, It seems like modes_rx (gr3.9 branch) under
GNU Radio 3.10 hangs somewhere on startup. @willcode4  will try to debug
it.

have a good day.

On 2022-10-02 19:52, Cinaed Simson wrote:
> Hi Michelle - the  source code version of gr-air-modes from github
>
>   https://github.com/bistromath/gr-air-modes.git
>
> indicates it should build under 3.9 but it doesn't build 3.10 - it
> can't find
>
>   GrSwig
>
> which is no longer supported.
>
> Sometimes OOT modules which work on 3.9 work on 3.10 - sometimes they
> don't.
>
> It's possible your version gr-air-modes has a different author from
> git hub version above.
>
> And I don't have a version of 3.9 either so I can't test it on 3.9 .
>
> -- Cinaed
>
>
>
> On 10/1/22 05:18, Michelle wrote:
>> Hello,
>>
>> I have gnuradio 3.10 and I wanted to install gr-air-modes. In the
>> chat one of the moderators told me the version of gr-air-modes that
>> is compatible with gr3.9 would work with gr3.10.
>> So I installed this version in my computer, the installation was
>> successfull however when I execute rx_modes I do not receive any
>> signal. The output of the command is :
>>
>> Inspiron-3793:~$ modes_rx
>> gr-air-modes warning: numpy+scipy not installed, FlightGear interface
>> not supported
>> [INFO] [UHD] linux; GNU C++ version 9.2.1 20200304; Boost_107100;
>> UHD_3.15.0.0-2build5
>> [INFO] [B200] Loading firmware image:
>> /usr/share/uhd/images/usrp_b200_fw.hex...
>> [INFO] [B200] Detected Device: B200
>> [INFO] [B200] Loading FPGA image:
>> /usr/share/uhd/images/usrp_b200_fpga.bin...
>> [INFO] [B200] Operating over USB 2.
>> [INFO] [B200] Detecting internal GPSDO....
>> [INFO] [GPS] No GPSDO found
>> [INFO] [B200] Initialize CODEC control...
>> [INFO] [B200] Initialize Radio control...
>> [INFO] [B200] Performing register loopback test...
>> [INFO] [B200] Register loopback test passed
>> [INFO] [B200] Setting master clock rate selection to 'automatic'.
>> [INFO] [B200] Asking for clock rate 16.000000 MHz...
>> [INFO] [B200] Actually got clock rate 16.000000 MHz.
>> [INFO] [B200] Asking for clock rate 32.000000 MHz...
>> [INFO] [B200] Actually got clock rate 32.000000 MHz.
>> Setting gain to 38
>> Gain is 38
>> Rate is 4000000
>>
>> please can i get some support to solve this problem?
>>
>>
>
>