Re: Sending a signal to a USRP N200

On 2021-09-06 5:33 p.m., isaac mario tupac davila wrote:
> Hi
>
> I've probed A:A, A:B, A:AB, A:BA and had the same behavior. Doesn't
> change.
>
> regards
> Isaac T
>
>
Could you confirm your signal power?  The Basic_RX has NO RF GAIN--which
means the peak input power would be around +7dBm approximately.
   The N200 (that's what you have--the drivers don't strongly
distinguish between the two types of device) has a 12-bit ADC, so it
should be able
   to "see" down to -60dBm or so, which some hand-waving because the
board isn't loss-free.
  The Basic_RX, being transformer-coupled does have some roll-off below
1MHz, but you should still be able to see your signal.