Re: [Discuss-gnuradio] Report on progress with Raspberry Pi 2

A simple WBFM radio receiver (RTL Source, Low Pass Filter, WBFM Receive, Audio Sink) works well with my Raspberry Pi2 and a RTL SDR. As soon as I add a FFT Sink (connected to the RTL Source) audio "stutters", is distorted and sometimes the program hangs. The indicated CPU load is well below 50 % in this case.

RTL-SDR (part of the osmocom rtl-sdr package) works fine with a Pi2.

Peter

On 12.04.2015 02:22, Mike Harpe wrote:

BLUF: I can get gqrx to run but not very well. It will run for a few seconds then hang badly. Sometimes the board needs to be rebooted.

After much goofing around getting it all setup again I ended up at the same place.

It runs but not very well with a Funcube Pro Plus. gqrx will come up and I do get choppy audio for a few seconds when tuned to a NOAA Weather Radio that is very close to me.

If anyone is interested I can provide more detail. Otherwise I am going to wait to see how this evolves.

Mike Harpe, N4PLE

Sellersburg, IN

_______________________________________________  Discuss-gnuradio mailing list  Discuss-gnuradio@gnu.org  https://lists.gnu.org/mailman/listinfo/discuss-gnuradio