if you plan to use any part of the USRP2's hardware (daughterboard, ADC, UART, ethernet, ...) and don't want to implement all the steps required to configure and use them properly, I would suggest to integrate your code parallel to the vanilla system (the UHD one!), it is far more work to get it running otherwise. The firmware does a lot of stuff. If you don't plan to use the hardware why not use a Spartan evaluation kit instead, they have nicer I/O capabilities for experimenting and testing?
Matthias
Am 09.02.2011 um 14:19 schrieb Eduardo Lloret Fuentes:
> Good morning,
>
> I have developed a custom FPGA design for my thesis and I would like to test it using the FPGA inside the USRP2. Since this design is just a combination of filters, multiplexers and signal generators and I am going to test it using an oscilloscope, not the GbE interface, I was wondering if I need to load the actual firmware (txrx.bin).
>
> Greetings,
>
> Eduardo.
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
No comments:
Post a Comment